Top Gasket for TM33 Mikuni Carburetor

3/4 ID Jack shaft spacers

Carburetor bowl bolts M4-0.7 X 10 socket heads. Sold in sets of four

Max Jets for Mikuni 42 and 45mm carburetors. Use to fine tune your carburetor!

Replacement lug nuts for your wheel studs. Sold in sets of three

Left and right 5/16" 24 thread rod ends

Are you getting air leaks in your fuel system? Try starting with replacing your 42mm carburetor float bowl O-ring!

Are you getting air leaks in your fuel system? Try starting with replacing your 33mm carburetor float bowl O-ring!

Front cover gasket for 42mm carburetor. If you've gone through your whole fuel system trying to find an air leak? Don't forget to check here!

Top gasket for any 42mm carburetor top.

3/4" ID locking collar.

1-1/4" locking collar. Is your axle wanting to shift? Lock it up with a couple of these and you won't have to worry about it again! Sold individually.

Jr dragster oil fill plugs, available in blue, purple, black, aluminum, and red.

2" oil fill plug sold with O-ring.

1" oil fill plug sold with O-ring.

Our easy strap/mount on tail lights come in 5 awesome colors! LED lights are bright and easily seen for max safety. Batteries Included!


Note, if you are racing NHRA sanctioned event, the strap must be removed via a small screw on the rear of the unit, A small hole drilled into your rear shield or other area and the screw replace through the car to permanently mount the light on the car to meet the rule listed on page 39 of the JDRL Rule Book. Using the strap on method is not NHRA legal. Please feel free to call for specific directions.

Standard carburetor bowl plug that fits a 42mm standard bowl and some 33mm bowls.

Rubber Seal for Mikuni HSR42/45 Throttle Valve.

If you're looking for something with maximum filtration and a lot of style, look no further than these bad boys! With 7 colors available you'll be sure to find something to match your car!

Long oil fill plug sold with O-ring.

For those of you using air mixture screws rather then air jets. Comes with spring, washer, and o-ring.

Fill plug extension tube to extend your fill plug up higher! Sold with O-ring.

Filter for 660 Pro EVAC system. 1.5 inch

Throttle butterfly for a mikuni 42mm carburetor.

Idle Cam for a 42mm carburetor. If your having problems with them breaking try taking out the stop screw!

Replacement 42mm carburetor jet needle.

Jr dragster long oil fill plug. Sold with o ring

Oil fill vent adapter for 1/2 inch NPT. Sold with o ring

Jr Dragster Oil Fill Extension. Sold With O-Ring