Alcohol prepared 33mm Mikuni Flat Slide Carburetor.
Needle and seat for 42mm or 33mm carburetor.
If your Mikuni Floats weigh more than 16 grams then you need new ones! Mikuni Floats for 42mm Jr Dragster alcohol carburetor.
Rubber carburetor flange for 42mm carburetor.
Easily adjust your idle to your precise launch rpm with our JDP custom carburetor top!
unmodified stock 42mm Mikuni flat slide carburetor. Save money and modify for alcohol yourself!
Get there with 660 Pro! Fully Built alcohol prepared 42mm carburetor by 660 Pro w/ Billet Top and High Capacity Billet Bowl w Fuel Runners.
Top of the line modified 42mm Choo Choo carburetor for those who want precise tuning! Comes with Choo Choo billet top and billet bowl.
Top notch 45mm Choo Choo carburetor by Lynn Haddock Ltd with a Dial-A-Jet for maximum fuel flow and performance! Comes with Choo Choo billet top and billet bowl. Own the best of the best.
1 quart aluminum fuel cell
1/4" Fuel line, Five feet of your favorite color!
Round Mikuni fuel pump.
Throttle butterfly for a mikuni 42mm carburetor.
Are you getting air leaks in your fuel system? Try starting with replacing your 42mm carburetor float bowl O-ring!
Tired of the bottom of your carburetor slipping out of the boot and costing you the round!! This is the best kit on the market for holding your carburetor in place! Fits in place of your current top holding mount and adds the second security of holding the bottom of the carburetor from slipping out of the boot. Includes an air filter adapter and all hardware needed!
Standard carburetor bowl plug that fits a 42mm standard bowl and some 33mm bowls.
Air filter adapter for a 33mm carburetor. This adapter is tapered for maximum air flow at maximum velocity. Get the power you need for more consistent Jr Dragster runs!
Air filter adapter for a 42mm or 45mm carburetor.
Save money by buying this factory 33mm carburetor and modify it yourself!
Max Jets for Mikuni 42 and 45mm carburetors. Use to fine tune your carburetor!
Carburetor bowl bolts M4-0.7 X 10 socket heads. Sold in sets of four
For those of you using air mixture screws rather then air jets. Comes with spring, washer, and o-ring.
Pilot jets sizes 52, 55, 57, 59, and 62. Don't get stuck at the track without the right jets for adjustments. Get what you need!
For those running a 33mm, 40mm, or 42mm carburetors with air bleeds rather than air mixture screws, don't get to the track without the jets to make the adjustments you need. Get what you need here!
33mm Intake flange with wide bolt pattern 2.900".
33mm Intake flange with small bolt pattern 2.312".
Genuine Mikuni T.V. Sealing Ring for HSR42/45mm throttle valve
Rubber Seal for Mikuni HSR42/45 Throttle Valve.
Genuine Mikuni HSR 42/45 throttle slide.
Top Gasket for TM33 Mikuni Carburetor
Back to top